Senseca HR1MV-040GM150E Flow transmitter with LCD (50 - 150 l/min, brass construction, DN 40)

Sensor: Analog Hall sensor

Nominal width: DN 40

Process connection: Female thread G 1 1/2

Metering range: 50 - 150 l/min

Qmax.: 230 l/min

Tolerance: ±3 % of full scale value

Pressure resistance: PN 200

Medium temperature: -20..+85 °C optionally -20..+150 °C

Ambient temperature: -20..+70 °C

Media: Water, oils (Gases and aggressive media available on request)

Wiring: see section "Wiring"

Power supply: 18..30 V DC

Power requirement: < 1 W

Analogue output: 0/4..20 mA, 0/2..10 V via a 500 W resistance after 0 V.

Switching values: S1 + S2

PNP or NPN, selectable, 300 mA max. load in total, programmable as min. value or max. value, resistant to short circuits, reversed polarity protected.

Display: graphical LCD display, extended temperature range -20..+70 °C, 32 x 16 pixels, Backlite, displays value and unit, flashing LED signal lamp with simultaneous message on the display.

Ingress protection: IP 67

Electrical connection: For round plug connector M12x1, 5-pole

Materials medium-contact

Brass construction: CW614N nickelled, CW614N, 1.4310, hard ferrite, NBR

Materials, non medium-contact: CW614N, PPS, glass

Weight: see table "Dimensions and weights"

Installation location

Standard: horizontal inwards flow; other installation positions are possible; the installation position affects the display, metering and switching range.

Datasheet