JISC HF-2 Handy Digital Force Gauge (20.00N / 2000 kgf / 2000gf / 4408lbf)

Max Capacity: 20.00N / 2.000 kgf / 2000gf / 4.408lbf

Resolution: 0.01N / 0.001kgf / 1gf / 0.001lbf

Unit: kgf, gf, lbf, N

Accuracy: 0.2% of F.S

Repeatability: 0.1% of F.S

Response: Variable, 10 to 32 Hz

Display: 4 Digit LCD

A/D Converter: 16 Bits

Calculation Device: 8 Bit CPU C-MOS Type

Allowable Load: 150% of F.S.

Data Output: Mitutoyo, Centronics, RS-232C ( Optional items required if non-Mitutoyo devices are used ).

Analogue Output: +/- 2V F.S

Continuous Operation Time: Approx. 10 hrs ( 25 degree C when fully charged )

Charging Time: Approx. 6 hrs ( Circuit preventing over-charging is built-in )

Operating Temperature: 0 to 40 degree C

Power: Ni-cad Battery, Feeder

CHARACTERISTICS

HF SERIES

The HF series is used not only for load measurements but also for a variety of tests including switch test. Connector’s insertion/ withdrawal test and break-down test. In addition, low-cost centronics interface which enables printing of measured data and statistical data through portable printer is also available.

Features

• High resolution

1/10000 resolution (1kgf, 10kgf, 100kgf type) which is not found in common hand held models.

• Memory function. Battery backup

Can memorize 512 unit testing data at most.

• Printing of inspection report

Inspection report can be printed in portable printer through Centronics Interface.

• Statistical processing

Automatic calculation and printing of standard deviation and process capability index.

• Insertion withdrawal measurement

Peak data under compression and peak data under tension can be done in one measurement.

• Mode setting

The HF series function not only act as a force gauge but is also designed to perform a variety of other measurements. In performing other measurements, mode setting enhances measurement efficiency.

• High functionality

Unit Change: gf, kgf, N ,lbf.

Measurement is possible during contact point hold (for switches normally open or normally close).

Digimatic output.

RS-232C (Cable is optional)

Analog output (2V F.S)

Auto memory with auto reset

comparator with upper and lower limit tolerance setting.

Peak hold with Break-Down detection.

continous operation by monitored charging function.

More than 8 hours of battery life.

Auto power OFF that is energy saving.

Overload alarm output.