FLUKE P3119-BAR High-Pressure Hydraulic Deadweight Tester (4000 Bar)

Pressure Ranges: 40 bar ~ 4000 bar

Instrumental Measurement Uncertainty Specification

Standard accuracy¹: ±(0.02% of reading or 0.001% of range, whichever is greater)

Optional (Improved Accuracy)²: ±(0.015% of reading or 0.00075% of range, whichever is greater)

¹ Correction factors are not necessary for the standard accuracy of 0.02% of reading when used within the following environmental limits:

Ambient temperature: 18°C to 28°C

Ambient pressure: 80 kPa to 105 kPa

Location: Local gravity adjusted weights

² Windows-based PressCal software is available to allow users to apply all necessary corrections for the specific piston range and accuracy.

Note: For more information on uncertainty, including the % reading threshold, refer to the technical note: “Guide for the Uncertainty Analysis in Pressure When Using P3000 Series Deadweight Testers”.

Materials of Construction

Standard weight materials: Series 3 non-magnetic austenitic stainless steel

Density: 7.8 g/cm³

Piston materials: Tungsten carbide with nickel binder

Cylinder material: Tungsten carbide with cobalt binder

Thermal coefficient of expansion: 11 ppm/°C

General Specifications

Test port adaptors: DH500. equivalent to HiP 60-xxxx high pressure fittings (60.000 psi) for 1/4” and 3/8” tube sizes

Weight: 23 lbs (10.5 kg)

Dimensions (W × D × H): 18” × 20” × 20” (457 mm × 508 mm × 508 mm)

Mass set weight: 100 lbs (45.5 kg)

Reservoir volume: 150 cc

Priming pump: Included with standard 3117, 3118 and 3119 models

Minimum weight increments: 2 bar, 0.2 MPa, 20 psi

Optional fine increment weights: Minimum increments of 0.2 bar, 0.02 MPa, 2 psi

Seal materials: Viton and Buna

Operating fluid: Sebacate, reference 3069551 (1 gallon standard)

Datasheet